User manual

3: GW1000 Series LED behaviour
_______________________________________________________________________________________________________
3.4 Signal strength LEDs
There are two signal strength LEDs. They are both green.
LEDs Colour Status
Green Off/off No signal detected.
Green flashing Off/on Low signal strength.
Green flashing On/off Medium signal strength.
Green On/on Good signal strength.
Table 8: Signal strength LED status descriptions
3.5 WiFi LED
The WiFi LED indicator is blue.
LED Colour Status
On WiFi is enabled.
Flashing Data activity on WiFi interface.
Table 9: WiFi LED status description
3.6 Ethernet port LED behaviour
The Ethernet port has two LEDs: a LINK LED (green) and an ACT LED (amber).
When looking at the port, the LED on the left hand side is the LINK LED, and the
ACT LED is on the right hand side.
Figure 3: Ethernet LED
Link LED
(green)
Off No physical Ethernet link detected.
On Physical Ethernet link detected.
ACT LED
(amber)
Off No data is being transmitted/received over the link.
Flashing Data is being transmitted/ received over the link.
_______________________________________________________________________________________________________
© Virtual Access 2015
GW1000 Series User Manual
Issue: 2.4 Page 16 of 255