User manual

23: Virtual Router Redundancy Protocol (VRRP)
_______________________________________________________________________________________________________
When you are logged in via an SSH session, run the command, vacmd show
vars
Figure 64: Output from the command vacmd show vars
Alternatively, when you are connected via the web interface, the software
version currently being used is presented at the bottom of the screen
Figure 65: The login screen showing the current software version
23.2 VRRP web interface
To configure VRRP through the web interface, in the top menu, select Network -
> VRRP. The VRRP page appears.
Figure 66: The VRRP page
_______________________________________________________________________________________________________
© Virtual Access 2015
GW1000 Series User Manual
Issue: 2.4 Page 154 of 255