User manual

2: GW1000 Series hardware
_______________________________________________________________________________________________________
5. Gently push the SIM card into SIM slot 2 until it clicks in.
2.14 Connecting the SIM lock
Connect the SIM lock using the Allen key provided.
2.15 Connecting cables
Connect one end of the Ethernet cable into port A and the other end to your PC
or switch.
2.16 Connecting the antenna
If only connecting one antenna, screw the antenna into the MAIN SMA
connector.
If using two antennas, screw the main antenna into the MAIN SMA connector
and the secondary antenna into the AUX SMA connector.
2.17 Powering up
The GW6600 takes approximately 2 minutes to boot up. During this time, the
power LED flashes.
Other LEDs display different diagnostic patterns during boot up.
Booting is complete when the power LED stops flashing and stays on steady.
2.18 Reset button
The reset button is used to request a system reset.
When you press the reset button all LEDs turn on simultaneously. The length of
time you hold the reset button will determine its behaviour.
Press Duration Behaviour
Less than 3 seconds Normal reset.
Between 3 and 5 seconds The router resets to factory configuration.
Between 20 seconds and 25 seconds Recovery mode.
Over 25 seconds Normal reset
Table 5: GW1000 Series router reset behaviour
_______________________________________________________________________________________________________
© Virtual Access 2015
GW1000 Series User Manual
Issue: 2.4 Page 14 of 255