User manual
2: GW1000 Series hardware
_______________________________________________________________________________________________________
2.12 Components
To enable and configure connections on your router, it must be correctly
installed.
The GW1000 Series router contains an internal web server that you use for
configurations. Before you can access the internal web server and start the
configuration, ensure the components are correctly connected and that your PC
has the correct networking setup.
The GW1000 Series router comes with the following components as standard:
1 x GW1000 Series router
1 x Ethernet cable. RJ45 connector at both
ends.
1 x power supply unit.
1 x right angle antenna.
Table 3: GW1000 Series router standard components
Optional components include:
1 x lockable SIM cover
1 x extra antenna Virtual Access supplies a wide range of antennas. Please visit our
website: www.virtualaccess.com or contact Virtual Access for more
information.
Table 4: GW1000 Series router optional components
2.13 Inserting the SIM cards
1. Ensure the unit is powered off.
2. Hold the SIM 1 card with the chip side facing down and the cut corner front left.
3. Gently push the SIM card into SIM slot 1 until it clicks in.
4. If using SIM 2 then hold the SIM with the cut corner front right
_______________________________________________________________________________________________________
© Virtual Access 2015
GW1000 Series User Manual
Issue: 2.4 Page 13 of 255