User manual

19: Configuring IPSec
_______________________________________________________________________________________________________
If xauth is defined as the authentication method then you must include an
additional config secret section, as shown in the example below.
strongswan.@secret[1].enabled=yes
strongswan.@secret[1].idtype=userfqdn
strongswan.@secret[1].userfqdn=testxauth
strongswan.@secret[1].remoteaddress=10.2.2.2
strongswan.@secret[1].secret=xauth
strongswan.@secret[1].secrettype=XAUTH
config secret
option enabled 'yes'
option idtype 'userfqdn'
option userfqdn 'testxauth'
option remoteaddress '10.2.2.2'
option secret 'xauth'
option secrettype 'XAUTH'
_______________________________________________________________________________________________________
© Virtual Access 2015
GW1000 Series User Manual
Issue: 2.4 Page 128 of 255