User manual

18: Automatic operator selection
_______________________________________________________________________________________________________
18.3.3 Roaming: no PMP defined
There is no primary interface that can be used for a connection. The router uses
the network that offers the best signal threshold.
Multi-WAN operation
17. Connect to the first roaming operator interface.
18. Check for signal strength every 'health_interval'. If the signal goes down below
'signal_threshold'
19. Disconnect from first roaming interface
20. Connect to second roaming operator interface.
21. Check for signal strength every 'health_interval'. Stays there until signal goes below
'signal_threshold'
22. Disconnect from second roaming interface. Go to 1.
From the top menu, select Network -> Multi-Wan. The Multi-WAN page
appears.
Figure 62: The multi-WAN page
Scroll to the WAN Interfaces section, and click Delete to delete predefined
Interface.
Click Save & Apply.
_______________________________________________________________________________________________________
© Virtual Access 2015
GW1000 Series User Manual
Issue: 2.4 Page 119 of 255