User manual

18: Automatic operator selection
_______________________________________________________________________________________________________
Check the Reboot now check box and then click Reboot.
18.3.2 PMP + roaming: pre-empt disabled
As in the previous section, multi-WAN connects the primary predefined interface
and uses auto created interfaces. However, in this scenario, the auto created
interface will not be disconnected as soon as the primary interface is available.
The primary interface will be reconnected when auto created interface is down
and when the ifup_retry_sec timeout expires.
The only change in configuration compared to the PMP + roaming: pre-empt
enabled example above, is that the pre-empt option in the multi-WAN package
must be disabled.
To disable PMP + roaming pre-empt, in the top menu, select Network -> Multi-
Wan.
In the Multi-WAN page, ensure Preempt is not selected.
Figure 60: The multi-wan page, pre-empt not selected
Click Save & Apply.
In the top menu, select System -> Reboot. The System Reboot page appears.
Figure 61: The system reboot page
Check the Reboot now check box and then click Reboot.
_______________________________________________________________________________________________________
© Virtual Access 2015
GW1000 Series User Manual
Issue: 2.4 Page 118 of 255