User manual

18: Automatic operator selection
_______________________________________________________________________________________________________
to APN.
Health Monitor
Interval
Dropdown menu Yes 10 sec Sets interval used
to monitor signal
strength.
Health Monitor
ICMP Host(s)
Dropdown menu No none Specifies target
IP address for
ICMCP packets.
Health Monitor
ICMP Timeout
Dropdown menu Yes 3 sec Specifies ICMP
timeout.
Attempts Before
WAN Failover
Dropdown menu Yes 3 Specifies number
of fail attempts of
Health Monitor
before interface
is torn down.
Attempts Before
WAN Recovery
N/A N/A N/A N/A
Priority Number Yes 0 Defines that the
higher value is
higher priority.
Minimum ifup
Interval
Dropdown menu Yes 300 sec Specifies
minimum interval
between two
successive
interface start
attempts.
Interface Start
Timeout
Dropdown menu Yes 40 sec Sets time for
interface to
startup.
Signal Threshold
(dBm)
Dropdown menu Yes -115 Specifies the
threshold where
if the signal is
lower than this
then it is marked
as fail.
When you have configured your settings, click Save & Apply.
In the top menu, select System -> Reboot. The System page appears.
Figure 59: The reboot page
_______________________________________________________________________________________________________
© Virtual Access 2015
GW1000 Series User Manual
Issue: 2.4 Page 117 of 255