User manual

18: Automatic operator selection
_______________________________________________________________________________________________________
Click Save & Apply.
18.3.1.2 Setting multi-WAN options for primary predefined interface
On the web interface go to Network ->Multi-Wan. The Multi-WAN page
appears.
Figure 53: The multi-WAN page
In the Multi-WAN page, click Add. The Multi-WAN page appears.
Figure 54: The multi-wan page
Check Enable.
Check Preempt.
Name Type Required Default Description
Enable Boolean Yes 0 Enables Multi-
Wan
Preempt Boolean No 0 Enables Preempt
mode
Alternate Mode Boolean No 0 Enables Alternate
Mode
In the WAN Interfaces section, type in the name of the Multi-WAN Interface.
Note: this name should match the name specified in the previous section.
_______________________________________________________________________________________________________
© Virtual Access 2015
GW1000 Series User Manual
Issue: 2.4 Page 111 of 255