User manual

17: Configuring Multi-WAN
_______________________________________________________________________________________________________
Icmp hosts No 3 secs Sets Ping timeout.
timeout No 3 secs Sets Ping timeout.
Health fail retries Yes 3
Specifies the amount of retries before the
interface is considered a failure.
Health recovery
retries
Yes 5
Specifies the number of healthy pings before
the interface is considered healthy.
failover to Yes
Load Balancer
(Compatibility)
This field is not applicable unless you have two
WAN interfaces connected simultaneously and
want to forward traffic to a specific interface
after the failover.
dns No Auto Defines DNS for the interface.
priority Yes 0
Specifies the priority of the interface, a higher
value is better.
1 is better than 0, therefore the interface with
priority of 1 will connect first.
manage state Yes Yes Specifies interface start/stop by Multi-WAN.
exclusive group No 0
Specifies which interface within the group is
active. Only one interface can be active: SIM 1
or SIM 2.
ifup retry sec Yes 300 secs
Specifies the time for interface to start up. If it
is not up after this period, it will be considered a
fail.
ifup timeout sec Yes 40 secs
Specifies the minimum interval between two
successive interface start attempts.
signal threshold Yes -150
Specifies the minimum dBm signal strength
before considering the interface as fail.
RSCP Threshold
for 3G (dBm)
Yes -150
Specifies the minimum RSCP signal strength
before considering the interface as fail.
ECIO Threshold
for 3G (dBm)
Yes -35
Specifies the minimum ECIO signal strength
before considering the interface as fail.
_______________________________________________________________________________________________________
© Virtual Access 2015
GW1000 Series User Manual
Issue: 2.4 Page 107 of 255