User manual

17: Configuring Multi-WAN
_______________________________________________________________________________________________________
option ecio_threshold '-15'
option ifup_timeout_sec '120'
~# uci show multiwan
multiwan.config=multiwan
multiwan.config.preempt=yes
multiwan.config.alt_mode=no
multiwan.config.enabled=yes
multiwan.wan=interface
multiwan.wan.disabled=0
multiwan.wan.health_interval=10
multiwan.wan.timeout=3
multiwan.wan.health_fail_retries=3
multiwan.wan.health_recovery_retries=5
multiwan.wan.priority=2
multiwan.wan.manage_state=yes
multiwan.wan.exclusive_group=3g
multiwan.wan.ifup_retry_sec=36000
multiwan.wan.icmp_hosts=disable
multiwan.wan.signal_threshold=-111
multiwan.wan.rscp_threshold=-90
multiwan.wan.ecio_threshold=-15
Config multiwan
Name
Required
Default
Description
Enabled
Yes
No
Enables or disables Multi-WAN.
Preempt No No
Enables or disables pre-emption for Multi-WAN. If enabled, the
router will keep trying to connect to a higher priority interface
depending on timer set.
alt mode No No
Enables or disables alternate mode for Multi-WAN. If enabled
the router will use an alternate interface after reboot.
Config interface
Name Required Default Description
Disabled No 0 Disables the Multi-WAN interface.
Weight No 10
Configures weight for load-balancing. Not
relevant when two SIM cards are being used.
Health interval No 10
Sets the period to check health status of
interface.
_______________________________________________________________________________________________________
© Virtual Access 2015
GW1000 Series User Manual
Issue: 2.4 Page 106 of 255