User guide

3G Wireless N150 Mini Router m1-User Guide YMLM1WN
10 www.netcomm.com.au
Getting Online in 5 Minutes:
Hardware Installation
1. Connect power to the NetComm m1 by either:
A) Connecting the supplied power adapter to a wall power outlet and to the port labelled Power on the side of the NetComm m1
B) Connecting the supplied USB cable to the port labelled Power on the NetComm m1 and connects both USB connectors on the
other end to compatible USB ports on your laptop/desktop computer.
2. Slide the power switch to the ON position and wait around 2 minutes to allow the device to power up.
3. Connect a compatible 3G USB Modem to the 3G USB port of the NetComm m1. If you are unsure whether your 3G USB Modem is
compatible with the NetComm m1, please check the compatibility list on the NetComm website.
Establishing WiFi Connection
The NetComm m1 creates a personal WiFi coverage zone to provide Internet access to WiFi enabled devices.
1. Using your WiFi enabled device, scan for wireless networks in your area and select the network called NetComm Wireless.
2. Enter the following default security key: a1b2c3d4e5
Note: For optimal WiFi security, we recommend that you change the default settings through the web based user interface. For more details, please refer to the section titled “Basic
Settings – Wireless”. .
Connecting your Device to the Internet
After completing the hardware installation, you will need to enter the necessary settings in order to be able to connect to your broadband
service provider. You can achieve this via the product’s web based user interface by following the steps below:
1. On your computer, open a web-browser (such as Internet Explorer, Firefox, or Safari), type 192�168�1�1 into the address bar at the
top of the page and press enter.
2. At the login screen, type “admin” into the system password eld. Then click Login to continue.
3. Next complete the setup wizard by lling in the details of your 3G connection. If you don’t know which settings to use here, please
contact your service provider to obtain this information.
4. If the SIM Card in your 3G USB modem was supplied with a PIN, enter it in the respective eld and conrm your PIN settings and
select ‘Remember PIN’ if you want the PIN stored on the device.
5. After completing the wizard, wait for 2 minutes to allow the NetComm m1 to connect to the internet.
6. If you are connected successfully, the blue 3G light on the top of the unit will be lit. You can also check on the status of your
connection if necessary by clicking ‘Status’ after logging in to the web based user interface