User guide

110 Settings
System Events
You can enable or disable, as a group, the logging of the following events:
● Software update available
● Primary WAN failover
● Primary WAN switchback
● Unexpected data connection loss
● Changes to miscellaneous settings
The following system events are always logged:
● Intrusion alerts
● Unexpected power loss
● Critical battery
● Critical temperature
● Routing hardware settings reset
● Firmware update
Enabling and Disabling Logging of System Events
1. Log in to the home page.
2. Click Advanced Settings > Device > Log.
3. In the Verbose System Event Logging section, select Enable or Disable.
4. Click Save.
Exporting System Events
1. Log in to the home page.
2. Click Advanced Settings > Device > Log.
3. Make sure Verbose System Event Logging is set to Enable.
4. Click Export.
Clearing the System Events Log
1. Log in to the home page.
2. Click Advanced Settings > Device > Log.
3. Make sure Verbose System Event Logging is set to Enable.
4. Click Clear log.
Note: Certain events are always logged. (See “System Events” [above].)