User manual

ix
About This Manual
This manual is written for users who are familiar with console commands. It
contains instructions on how to configure your router for different network configurations.
Chapter 1 - Setting Up Local Management guides you on how to setup and establish
a communication link between your router and PC. With this local mangement
established, you can then start issuing console commands.
Chapter 2 - Basic Commands on Running Local Management gives the basic
commands to run the local management.
Chapter 3 - Configuring Your Router guides you on how to configure your router for
different network configurations. A Configuration Flow Chart is provided. The line
protocols discussed are RFC 2684 (RFC 1483) Ethernet Framing, RFC 2684 (RFC
1483) IP Framing, RFC 2225 (RFC 1577) IP over ATM, RFC 2364 PPPoA and RFC
2516 PPPoE. The configuring of NAT Inbound Port Forwarding, DHCP Server, DNS
Relay and so on, can also be found in this chapter.
Chapter 4 - Configuring Your Transparent Bridge guides you on how to configure
your router for transparent bridge.
Chapter 5 - Router Configuration Examples give you router configuration examples
based on RFC 2684 (RFC 1483) IP Framing and RFC 2364 PPPoA.
Chapter 6 - Configuring PPTP (Point-to-Point Tunnelling Protocol) guides you on the
console commands and setting up of the dial-up networking for PPTP.
You will be able to find detailed descriptions of the console commands at Appendix
A - Commonly Used Commands and the commonly used TCP/UDP Ports at Appendix
B - Well-Known TCP/UDP Ports.