User manual

6 — Configuring PPTP (Point-to-Point Tunnelling Protocol)
6-2
6.1.3 Step 3 - Binding to Ethernet Interface
Configure the PPTP process to bind to an Ethernet interface and to setup tunnel 1
to listen (waiting for the PNS to initiate the connection). Assuming that the IP
address given is 192.168.1.1.
pptp bind 192.168.1.1
pptp 1 create listen
config save
6.2 Setting Up Dial-Up Networking
i) From your Windows desktop, right-click on Network Neighborhood icon and
select Properties.
ii) Click on Add.
iii) Select Adapter and click Add.
iv) From the Manufacturers list, scroll down and select Microsoft.
From the Network Adapters list, select Dial-Up Adapter and click OK.
(DO NOT remove the existing Dial-Up Adapter from the network component
list.)
You should see Dial-Up Adapter #2 (VPN Support) listed in the components
list as shown.
v) Repeat step(ii) and step(iii).
From the Manufacturers list, scroll down and select Microsoft.
From the Network Adapters list, select Microsoft Virtual Private Networking
Adapter and click OK.