User manual

2 — Basic Commands on Running Local Management
2-3
For commands in section 2.5, changes will take effect only after
you have re-established the line by issuing a
bsp down and bsp up
commands (see section 2.4).
For changes to be permanent, please follow by a
config save
command.
2.4 To Disconnect/Connect the ADSL Link
i) To disconnect the ADSL link:
bsp down
(Upon issuing this command, ADSL Link will be disconnected unless the
following command is issued.)
ii) To re-connect (establish) the ADSL link:
bsp up
2.5 To Toggle between Various Modes
i) To set router to multimode (auto-detect G.dmt, G.Lite & ANSI TI.413):
bsp multi
ii) To force router into detecting G.Lite only:
bsp glite
iii) To force router into detecting G.dmt only:
bsp gdmt
iv) To force router into detecting ANSI T1.413 only:
bsp ansi