User manual

2 — Basic Commands on Running Local Management

2-2

2.2 Checking Your Router Performances

i) To check for line parameters:

bsp line

ii) To check for line performance:

bsp perf

iii) To check for line status:

bsp mode

iv) To check net data rate:

bsp channel

v) To monitor traffic:

bun list channels

2.3 Checking Your Router Entries

Messages displayed are the settings you have saved.

i) To list existing interfaces:

ip device

bridge device [for Transparent Bridge and RFC 2684 (RFC 1483) Ethernet Framing]

ii) To list existing subnet mask:

ip subnet

ppp 1 lansubnet (for RFC 2364 and RFC 2516)

iii) To list existing route table (not applicable for Transparent Bridge)

ip route