Installation guide

BB005x Installation and Configuration Guide
RFC 1483 Bridged mode using non-default settings
If your configuration does not use the factory default settings, please go
through the following steps in order to configure the Gnet BB005x
modem/router.
1. Ensure that the RJ-11 Phone Line cable is disconnected from your
modem.
2. Connect the RJ-45 Ethernet cable between your computer and the
modem. Please remove the serial cable if it is connected.
3. Connect the AC Power adapter and turn on the Gnet ADSL
modem/router.
4. Close all programs.
5. Proceed to confirm or change, if necessary, the settings of the network
card on your computer by using the procedures described in the
Changing your computer settings section: Procedure A for Windows
95/98/ME or Procedure C for Windows 2000/XP. In all cases the
“known IP address” value to be entered is 192.168.7.2
6. Close all programs.
7. Launch your web browser.
8. In the address bar of your web browser type: 192.168.7.1
You will now see the following screen:
9. Click on System.
10. Click on Clear config.
11. For the User Name type admin (lower case). For the Password type
admin (lower case)
12. Click on the OK button. You will now see the following screen:
22