User Manual

Installation

3.2 Disinfection Procedure

UV disinfection is a physical disinfection process and does not add any potentially harmful chemicals to the water. As UV

does not provide a disinfection residual, it is imperative that the entire distribution system located after the UV be chemically

disinfected to ensure that the plumbing system is free from any bacteriological contaminants. The disinfection process must

be performed immediately after the UV unit is installed and repeated thereafter whenever the UV is shut down for service,

without power, or inoperative for any reason. The procedure for sanitizing the plumbing system is readily accomplished as

follows:

• Place sleeve bolt onto the

quartz sleeve, carefully push

down and hand tighten onto

chamber.

1010

• Insert lamp into the quartz

sleeve and thread into sleeve

bolt until hard stop.

• Connect the green ground

wire and red strain relief wire

to the chamber using the

grounding screw.

• Align connection pins with

the lamp connector by

rotating the ring clamp.

• Push the lamp connector

down onto the lamp pins and

the ring clamp pins until an

audible click is heard.

Note: Ensure the connector

is engaged on both sides.

1313

• Connect power.

• Open all faucets and turn on

water supply. Inspect for any

leaks.

Note: Outlet must be

protected by a Ground Fault

Circuit Interrupter (GFCI).