- ViPowER, Inc. VP-8220 SmartDup Installation Manual

SmartDup VP-8220 Operation Manu 5
-----
L4(Test & CopyMode) DIP SW1 atON position, 234atOFFposition-----
f you adjust DIP SWto L4,all operationsteps same as H4, theRecording
H4(Test & CopyMode) DIP SW1 4at ON position, 2 3at OFFposition
Speed will drop to 4xonly.
4-1.Turn RockSwitch to position(CD Duplicator). LED will showversion
number.
4-2. Than LED display showing:from 00,11, 22, 33,......88, 99
4-3. Duplicator will chk itself& getready.
4-4. SmartDup ready, pleaseinsert your CD title intoyour CD-ROMDrive &
Blank CD-R or CD-RW Media in CD-RW Writer.
4-5. LED Display showing final counts down, than LED showing H4 or L4.
4-6. LED Display showing CD-R or CD-RW Media maximum writing speed.
4-7. LED Display showing CD-R or CD-RW Media minimum writing time remaining.
4-8. After Test success, Buzzer Beep & LED showing 00. Than re-start Copy.
4-8-1. If fail, LED will show: Er & eject CD-R Media also.
4-9. LED Display showing CD-R or CD-RW Media maximum writing speed.
4-10. LED Display showing CD-R or CD-RW Media minimum writing time
remaining.
4-11. After Copy success, Buzzer will Beep & eject CD-R media. LED showing 00
.
4-11-1. If fail, LED will showing: Er & eject CD-R Media, Buzzer will Beep also
.
I
Please make sure CD-R or CD-RW media is blank.
display firmware version number. (Buzzer 0.5s X1)
ex:
Power-On:
Only one segment is running and display "rd" (ready)Self-Test:
After drives & discs ready in current mode, wait for
5 seconds. (Buzzer 0.2s X1)
ex:
Count Down:
or
After Self-Test or Test or Erase or Copy. (Buzzer 1sX2)OK:
After Self-Test or Test or Erase or Copy or Upgrade. (Buzzer 0.2X3)FAIL:
or
CD-R Maximum Writing Speed:
or
During Test or Copy mode. Flash every second
ex:
Remain minutes:
or or
After Self-Test or Test or Erase or Copy. (Buzzer 1sX2)OK:
After Self-Test or Test or Erase or Copy or Upgrade. (Buzzer 0.2X3)FAIL:
or
CD-R Maximum Writing Speed:
or
During Test or Copy mode. Flash every second
ex:
Remain minutes:
or or