- ViPowER, Inc. VP-8220 SmartDup Installation Manual

H1 (Upgrade firm-ware): DIP SW 3 4 at ON position, 1 2 at OFF position---
1 1. Turn Rock Switch to position (CD Duplicator). LED will show version number.
1-2. Than LED display showing: from 00,11, 22, 33, ......88, 99
1-3. Duplicator will chk itself & get ready.
1-4. Please insert your new Firm-Ware CD title into your CD-ROM Drives,
operation step as below:
1-4-1. Please down load new Firm-Ware from www.vipower.com.tw or
www.vipower.com to HDD.
1 4 2. Switch your power switch to (PC interface)
1-4-3. Please check Optional Step (page 10)
1-4-4. Burning new Firm-Ware into your CD-R or CDR-W media.
1-5. LED Display showing final counts down. Than LED showing H1 or L1.
1-6. SmartDup will upgrade automatically.
1-7. After Upgrade success, Buzzer will Beep & eject Firm-Ware Title. LED
showing 00.
1-8. Showing new firmware version.
1-8-1. If fail, LED will showing: Er & eject CD-R Media, Buzzer will Beep also.
If you adjust DIP SW to L1, all operation step same as above, the Recording
Speed will drop to 4x only.
display firmware version number. (Buzzer 0.5s X1)
ex:
Power-On:
Only one segment is running and display "rd" (ready)Self-Test:
After drives & discs ready in current mode, wait for
5 seconds. (Buzzer 0.2s X1)
ex:
Count Down:
After Self-Test or Test or Erase or Copy. (Buzzer 1sX2)OK:
After Self-Test or Test or Erase or Copy or Upgrade. (Buzzer 0.2X3)FAIL:
2 SmartDup VP-8220 Operation Manu