- ViPowER, Inc. VP-8220 SmartDup Installation Manual

Install Steps:
Caution:
New Firm-Ware download:
1. Install CD-RW Writer & CD-ROM Driver in each CD-ROM box. Must put rubber
stand on each CD-ROM box.
2. CD-ROM Driver on top & CDR or CD-RW Writer on the bottom.
3. Plug in Duplicator Converter in both CD-ROM box connectors.
4. Plug in Power Cable in Duplicator Converter.
5. Plug in Power Cord to AC Power source (+90 ~ +250VAC).
6. 36 pin IDE cable connect between SmartDup & your PC or Note Book interface
port.
7. Turn your Power switch to (PC interface), LED Display will blinking.
8. Make sure install success.
9. You can start back-up your Data/ Audio/ Video.
1. Make sure CD-RW burning software can recognize CD-RW writer.
2. Make sure your CD-R or CD-RW media acceptable maximum writing speed.
3. Maximum data transfer rate (byte/sec)
4. CD-RW Driver Maximum Writing Speed through PC Interface:
(1.) PCMCIA: 8 x
(2.) CardBus: 16 x
(3.) USB 1.1 Version: 4 x
(4.) USB 2.0 Version: 20 x
(5.) FireWire IEEE 1394: 20 x
1. Same as 1~ 8 at page 11.
2. Please down load new Firm-Ware from or
to HDD.
3. Put CD-RW or CD-R media in to your CD-RW writer.
4. CD-RW writer as External CD-RW writer.
5. Start Copy New Firm-Ware to RW media.
6. Back to Page 3.
Install Step
www.vipower.com.tw
www.vipower.com
PCMCIA CardBus USB 1.1 USB 2.0 FireWire
4X 600K 600K 600K 600K 600K
6X 900K 900K 900K 900K 900K
8X 1200K 1200K 900K 1200K 1200K
24X 2000K 3600K 900K 3600K 3600K
32X 2000K 3600K 900K 4800K 4800K
40X 2000K 3600K 900K 6000K 6000K
10 SmartDup VP-8220 Operation Manu