Install guide

ManualsBrandsViper ManualsAutomotive9251VL

Rev.: 20120112

Platform: DBALL/DBALL2

Firmware:

LINCOLN Remote Start Ready Installation

Remote Start Ready (RSR) is a function that enables the interface module to remote start the vehicle

on its own. Consequently, there is no need for an aftermarket or an OEM remote starter in order to

start the vehicle from a distance. An RSR solution is commonly referred to as a Standalone installation.

completely

Door lock and key interface for Lincoln & Ford Push-To-Start (PTS) vehicles.

*3x OEM Lock Remote Start Activation is a feature that allows users to control the aftermarket remote

starter using the factory (OEM) remote control. See page 2 for more information.

Only available on certain models, check the Vehicle Application Guide for compatibility with specific year and

model.

Note:

This guide supports the installation of a DBALL in Remote Start Ready (RSR) mode. This solution offers

three (3) configuration options to control your system; 3x OEM Lock Remote Start Activation*, RF Kit or

SmartStart (all sold separately). Refer to page 12 for a list of RF kits and their part numbers.

SmartStart Compatible

See page 6 for more information.

† Ford and Lincoln are registered trademarks and property of their respective companies.

EIPS Feature...................................................................................................................................................................

Vehicle Application Guide

Installation

................................................................................................................................................

Locating Key Components in the Vehicle........................................................................................................................

Type 1: Wiring Diagram - RSR (Remote Start Ready)....................................................................................................

Type 2: Wiring Diagram - RSR (Remote Start Ready)....................................................................................................

RSR (Remote Start Ready) XL202 or SmartStart connection for Type 1 & Type 2......................................................

Important Information.......................................................................................................................................................

Feature & Option List.......................................................................................................................................................

...............................................................................................................................................................

Programming

Feature Programming......................................................................................................................................................

LED Diagnostics and Troubleshooting.............................................................................................................................

Optional RF Kits

Limited One-Year Consumer Warranty............................................................................................................................

Module Programming & Reset.........................................................................................................................................

Index

Installation Guide

Update Alert: Firmware updates are posted to the web on a regular basis. We recommend

that you check for firmware and/or install guide updates prior to installing this product.

Summary of content (12 pages)

PAGE 1
Platform: DBALL/DBALL2 Firmware: LINCOLN Remote Start Ready Installation Rev.: 20120112 Update Alert: Firmware updates are posted to the web on a regular basis. We recommend that you check for firmware and/or install guide updates prior to installing this product. Installation Guide Door lock and key interface for Lincoln & Ford Push-To-Start (PTS) vehicles. This guide supports the installation of a DBALL in Remote Start Ready (RSR) mode.
PAGE 2
Platform: DBALL/DBALL2 Firmware: LINCOLN Remote Start Ready Installation Rev.: 20120112 Page 2 EIPS (Engine Idle Protection Shutdown) Vehicles equipped with RFID type Push-to-Start ignition systems work by detecting a proximity key in the vehicle. They will run indefinitely if the key is removed, which could potentially lead users to exiting the vehicle while the engine is still running and the car is left idling on its own in a garage or a confined space.
PAGE 3
Platform: DBALL/DBALL2 Firmware: LINCOLN Remote Start Ready Installation Rev.
PAGE 4
Platform: DBALL/DBALL2 Firmware: LINCOLN Remote Start Ready Installation Rev.: 20120112 Page 4 Installation Type 1: Wiring Diagram - RSR (Remote Start Ready) Brown C2153E at RFA module 1 pin 2: (+) Brake Violet/White 2 3 4 5 6 Blue C2153C at RFA module Remote Function Actuator (RFA) (see part location on page 3.) White C2153D at RFA module 5 7 4 3 2 7 8 9 10 11 12 13 6 13 12 11 10 9 15 16 17 18 19 20 21 22 23 Suggested power source: pin 1: (+) 12v, Blue/Red.
PAGE 5
Platform: DBALL/DBALL2 Firmware: LINCOLN Remote Start Ready Installation Rev.: 20120112 Page 5 Installation Type 2: Wiring Diagram - RSR (Remote Start Ready) Brown C2153E at RFA module 1 pin 2: (+) Brake Yellow/Green 2 3 4 5 6 Blue C2153C at RFA module Remote Function Actuator (RFA) (see part location on page 3.) White C2153D at RFA module 5 7 4 3 2 7 8 9 10 11 12 13 6 13 12 11 10 9 15 16 17 18 19 20 21 22 23 Suggested power source: pin 1: (+) 12v, Blue/Red.
PAGE 6
Platform: DBALL/DBALL2 Firmware: LINCOLN Remote Start Ready Installation Rev.: 20120112 Page 6 Wiring Diagram - RSR (Remote Start Ready) SmartStart is optional and not included. It MUST be purchased separately. The optional XL202 and antenna are not included and MUST be purchased separately.
PAGE 7
Platform: DBALL/DBALL2 Firmware: LINCOLN Remote Start Ready Installation Rev.: 20120112 Page 7 DBALL/DBALL2 Module Programming Refer to the LED Diagnostics section on page 9 for more information and for troubleshooting purposes. Important Make all the required connections to the vehicle, as described in the wiring diagram(s) found in this guide, and double check to ensure everything is correct prior to moving onto the next step.
PAGE 8
Platform: DBALL/DBALL2 Firmware: LINCOLN Remote Start Ready Installation Rev.: 20120112 Page 8 Feature and Option List Feature Operation RF Output Type Option No RF Output* 1 Activate this feature whenever an external RFTD module is used (i.e. SmartStartTM, XL201 or XL202). RFTD Output 2 Comfort Closure with lock Disabled Windows Only Windows + Sunroof* ** Important The RF Output Type function must be set to RFTD Output to enable the Remote Start Ready (RSR) mode.
PAGE 9
Platform: DBALL/DBALL2 Firmware: LINCOLN Remote Start Ready Installation Rev.: 20120112 Page 9 LED Diagnostics and Troubleshooting LED Status Description Troubleshooting This can also mean there is an issue with the data bus wiring. Make sure the connections to the data bus are correct by referring to the wiring diagram. Note: You can press the programming button 5 times to skip this step.
PAGE 10
Platform: DBALL/DBALL2 Firmware: LINCOLN Remote Start Ready Installation Rev.: 20120112 Page 10 Optional RF Kits Note: RF kits are sold SEPARATELY. Request an order from Directed using the part numbers listed below. 9211VL Viper 1-Way Responder ONE - Plug & Play RF Kit with XL202. UPC: 093207 08488 1 Also available as: § Python: 9211PL § Clifford: 9211XL 9153VL Viper 1-Way - Plug & Play RF kit with XL202.
PAGE 11
Platform: DBALL/DBALL2 Firmware: LINCOLN Remote Start Ready Installation Rev.: 20120112 Page 11 Optional RF Kits Note: RF kits are sold SEPARATELY. Request an order from Directed using the part numbers listed below. AF-RFK636 AF-RFK5225 Astrostart 2-way LED Receiver kit with up to 1,500’ of range. UPC: 093207 08752 3 Astrostart 2-way LCD Receiver kit offering TM XRT technology with up to 5,000’ of range.
PAGE 12
Platform: DBALL/DBALL2 Firmware: LINCOLN Remote Start Ready Installation Limited One Year Consumer Warranty Rev.: 20120112 Page 12 For a period of ONE YEAR from the date of purchase of a Directed Electronics remote start or security product, Directed Electronics.