Installation guide

primary harness (H1), 16-pin connector

NOTE: The labels for the pin numbers of this harness are located on the front of the plug, which is

the same side of the plug depicted in this diagram.

______

*IMPORTANT! The siren data wire should only be connected to the siren’s VIOLET tag wire. Do not

connect this wire to anything else.

LIGHT IN (PARKING LIGHT INPUT)

LIGHT OUT 5 AMP (PARKING LIGHT OUTPUT #2)

NORMALLY OPEN INTERRUPT OUTPUT #3

NORMALLY OPEN INTERRUPT INPUT #3

NORMALLY OPEN INTERRUPT OUTPUT #2

(-) SIREN 200 mA (NEGATIVE SIREN OUTPUT)

NORMALLY OPEN INTERRUPT INPUT #2

(-) HORN 200 mA (NEGATIVE HORN HONK OUTPUT)

LIGHT OUT 5 AMP (PARKING LIGHT OUTPUT #1)

(-) STARTER 500 mA (NEGATIVE GROUND-WHEN-ARMED OUTPUT)

SIREN DATA* SIREN DATA INPUT

(-) DOOR (NEGATIVE DOOR TRIGGER INPUT, ZONE 3)

(-) INST (NEGATIVE INSTANT TRIGGER, ZONE 1)

(+) DOOR (POSITIVE DOOR TRIGGER INPUT, ZONE 3)

(-) SENSOR (NEGATIVE SENSOR, ZONE 4 MULTIPLEX)

(-) DOME 200 mA ( NEGATIVE DOMELIGHT SUPERVISION OUTPUT)

H1/1

H1/2

H1/3

H1/4

H1/5

H1/6

H1/7

H1/8

H1/9

H1/10

H1/11

H1/12

H1/13

H1/14

H1/15

H1/16