® NO ONE DARES COME CLOSE ® O W N E R’ S G UIDE M O D E L 420 5 V
Congratulations Congratulations on the purchase of your remote start system. Reading this Owner’s Guide prior to using your system will help maximize the use of your system and its many features. For any additional questions please contact your authorized Directed dealer or contact Directed at 1-800-753-0600. (U.S. only) or 1-800-361-7271 (Canada only) Additional support is also available at: http://support.directed.
Battery Information The remote control is powered by two coin cell batteries (CR-2016) that can be purchased at most retailers. The operating range diminishes as the battery charge depletes. Replacing the Battery 1. If present, remove the small screw on the back of the remote. 2. Use a small flat blade screw driver and insert it into the slot located along the bottom of the remote, near the key ring. Carefully pry open the case. 3.
Contents Congratulations..................................................................................................i Important Information..........................................................................................i Government Regulations and Safety information.............................................i Your Warranty............................................................................................i Replacement remote controls.................................................
Using Your System Commands At a Glance System State Press/Release Press/Hold for 3 sec. ENGINE OFF START ENGINE CAR FINDER ENGINE ON UNLOCK DOORS STOP ENGINE Start Engine When the engine is OFF, press and release the remote control button to start the engine. The remote plays the remote start activation tones and the green LED flashes once. See"Using Remote Start" on page 3 for more feature details. Unlock Doors When the engine is ON, press and release the remote control button.
Car Finder When the engine is OFF, press and hold the remote control button for three seconds. The parking lights flash ten times. The remote responds with 1 short beep and the orange LED on the remote flashes once. Using Remote Start Important! (1) Never remotely start the vehicle with the vehicle in gear, and (2) Never remotely start the vehicle with the key in the ignition. Starting the Engine: 1. Press and release the remote control button. 2.
Note If your vehicle uses a Smart Key or PTS (Push-To-Start) system, please refer to the vehicle specific instructions included with the owner's guide of the interface module or consult your authorized dealer. Safety Features The following safety features will disable the remote start when activated or not allow the engine to start if not properly set before starting.
Note If your vehicle uses a Smart Key or PTS (Push-To-Start) system, please refer to the vehicle specific instructions included with the owner's guide of the interface module or consult your authorized dealer. Optional Rear Defogger If connected, the Defogger circuit automatically activates after remote starting the vehicle.
Remote Programming 1. 2. 3. 4. 5. 6. Turn key to the ON position Within 10 seconds, press and release Valet button one time. Within 10 seconds, press and hold the Valet button. The LED on the module flashes one time and the horn honks (if connected) to confirm entry into remote programming. Do not release the valet button. Press the button on the remote control. The horn honks to confirm the remote has been programmed. Release the Valet button. Turn the key to the Off position.
Ignition switch controlled door locking on or OFF. With this feature on, the doors will lock 3 seconds after the ignition key is turned on, and unlock when the key is turned off. Important: The door lock option must be installed for this feature to work.
Government Regulations This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesirable operation. This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules.
Warning! Safety first The following safety warnings must be observed at all times: Installation Due to the complexity of this system, installation of this product must only be performed by an authorized Directed dealer. Remote Start Capable When properly installed, this system can start the vehicle via a command signal from the remote control. Therefore, never operate the system in an enclosed area or partially enclosed area without ventilation (such as a garage).
consult with the authorized Directed dealer to fix the problem. After the remote start module has been installed, contact your authorized dealer to have him or her test the remote start module by performing the Safety Check outlined in the product installation guide. If the vehicle starts when performing the Neutral Safety Shutdown Circuit test, the remote start unit has not been properly installed.
Water/Heat Resistance This product is not designed to be water and/or heat-resistant. Please take care to keep this product dry and away from heat sources. Any damage from water or heat will void the warranty. © 2013 Directed. All rights reserved.
Limited lifetime consumer warranty Directed Electronics.
IN THE EVENT OF A CLAIM OR A DISPUTE INVOLVING DIRECTED OR ITS SUBSIDIARY, THE VENUE SHALL BE SAN DIEGO COUNTY IN THE STATE OF CALIFORNIA. CALIFORNIA STATE LAWS AND APPLICABLE FEDERAL LAWS SHALL APPLY AND GOVERN THE DISPUTE. THE MAXIMUM RECOVERY UNDER ANY CLAIM AGAINST DIRECTED SHALL BE STRICTLY LIMITED TO THE AUTHORIZED DIRECTED DEALER’S PURCHASE PRICE OF THE UNIT.
The company behind Viper® Auto Security Systems is Directed. Since its inception, Directed has had one purpose, to provide consumers with the finest vehicle security and accessories available. The recipient of nearly 100 patents and Innovations Awards in the field of advanced electronic technology. Quality Directed products are sold and serviced throughout North America and around the world. Call (800) 876-0800 for more information about our products and services. © 2013 Directed. All rights reserved.
Guide Translations Quick Reference Install Guide For a Spanish version of the Installation Guide, please download it from www.directechs.com under Resources. Remote Start with Keyless Entry 4205-series, 1-button remote Estimado Cliente: Si buscas los guías de instalación, por favor de bajar lo del Resources en el sitio www.directechs.
Programming System Features Feature Menus Remote Programming The System Features Learn Routine dictates how the unit operates. It is possible to access and change most of the feature settings using the Valet button. Default settings are in bold type. 1. 2. 3. 1. 2. 3. 4. 5. Turn the ignition on, then off. Select a Menu. Within 10 seconds, Press and hold the Valet button. The number of LED flashes and horn honks indicates the menu number. A single LED flash and honk indicates menu 1.
