User Manual

GLD Products Solar Blast Dartboard
Item 42-1021
1-800-225-7593 8
www.gldproducts.com
POWER INSTALLATION
The dartboard is designed to be powered by an AC to 5V DC, 500 milliamp (minimum)
adapter, with the DC plug polarity configured as positive (+) outside, and negative (-) center.
To connect the adapter, plug the DC plug into the DC power jack on the dartboard and the
AC plug into an electrical outlet.
1. The board is not intended for children under the age of 12 years old.
2. The board must only be used with the recommended transformer.
3. The transformer is not a toy.
4. Disconnect the dartboard from the transformer before cleaning.
PROTECTIVE FILM
This electronic dartboard has a clear protective film over the entire display and button area
to prevent scratching during shipping. It is recommended that you remove this film for easier
reading of the display. To remove, simply lift edge, peel off and discard.
WARNING: Not for use by children without adult supervision.
Darts are not toys and may cause injury if used
improperly. Everyone must stand behind the dart
thrower.
IMPORTANT NOTES
1. During shipping or in the course of normal play, it is possible for scoring segments of this
board to become temporarily jammed, resulting in a “frozen” board. If this occurs, the
built-in Self Diagnostic Function of the e-BOARD Computer will be activated
automatically. Your dartboard will run a self-test routine to determine which segment is
stuck. An error message will flash on the display together with the number for the
“Frozen” segment.
Error Code Malfunction
ERR F11 Stuck # of Players Button
ERR F10 Stuck Double In/Out Master Out Button
ERR F09 Stuck Game Options Button
ERR F08 Stuck Team Button
ERR F07 Stuck Bounce Out Amend Button
ERR F06 Stuck Game Menu Button
ERR F04 Stuck Start Game/Next Player Button
ERR F03 Stuck Solo Play Button
ERR F02 Stuck Sound Control Button
ERR F01 Stuck Back/Auto Change Button
ERR F00 Stuck Eliminate Score/Single/Double Bull Button
ERR XX x X A segment is stuck, the first two XX indicates the number of the
segment, the last X is a 1, 2 or 3 (single, double or triple
segment).