OWNER'S GUIDE M 0 0 E 4105V L
Congratulations Congratulations on the purchase of your state-of-the-art keyless entry and remote start system. Reading this Owner's Guide prior to using your system will help maximize the use of your system and its many features. Please visit: www.viper.com - For general and additional guide information. For any additional questions please contact your authorized Directed dealer or contact Directed at 1-800-753-0600 (U.S. only). Additional support is also available at: http:// support. directed.com.
Importnntinformotion__ Government Regulations and Safety information II © 2012 Directed. All rights reserved.
Contents Congratulations .............................................................. .................................. i What's included .............................................................. ............................... ! Your warranty .............................................................. .............................. i Impor tan t .1n forma t•1on .............................................................. .......................... ..
Remote_Control information information Used to perform arming, disarming, auxiliary channel and remote start commands © 2012 Directed. All rights reserved.
Remote _rontr_ol fu netions_________ The remote buttons are used to send commands to the system. The buttons indicated below are for standard configuration. Standard configuration ~ Button The lock function is controlled by pressing ~ on the remote control for one second. When held for approximately two seconds, Panic is activated. 3 Button The unlocking function is controlled by pressing 3 on the remote con- trol for one second. You can also turn Panic off with this button. £(Wb.
~ and * and £~ Buttons When simultaneously pressed these buttons control the optional rear window defogger during remote starting. The parking lights flash three times to confirm activation. Once activated the defogger will turn on whenever the vehicle is remote started. The parking lights flash twice when the defogger is deactivated. The defogger does not turn on when the vehicle is remote started. Important note: Defogger is an optional feature. Additional parts and labor may be required.
Using the system Locking ~ for one second locks the system (if the door locks are connected}. The horn honks and the parking lights flash once to confirm the system is locked. The Failsafe® Starter Kill also activates and prevents Pressing the vehicle's starter from cranking . Important note: Horn honk and Failsafe are both optional features. Unlocking Pressing 8 for one second unlocks the doors (if connected). The horn honks twice and the parking lights flash twice to confirm unlocking of the system.
Panic Mode If you are threatened in or near your vehicle, you can attract attention by triggering the system with your remote control. Press {5 for approximately two seconds to enter Panic Mode. In Panic Mode, the horn will honk and the parking li~ts will flash for 30 seconds. To stop Panic Mode at any time, press (5, or {5 on the remote control. Note: In order for Panic Mode to be effective, the vehicle's horn (or optional siren) and the vehicle's parking lights must be connected.
is triggered. Warningl It is unsafe to operate a vehicle's motor in a garage or other closed off area. Breathing the exhaust from the vehicle is hazardous to your health. Never activate the remote start in an enclosed space. When you are ready to drive the vehicle: l. Insert the ignition key and turn it to the ON (not the START) position. 2. Press the brake pedal. The remote start system shuts down and the engine continues to run because the ignition has been turned on.
Valet Toke-Over The Valet Take-Over feature allows the vehicle to remain running after the key has been removed from the ignition. This feature is useful for occasions when you wish to exit and lock the vehicle for short periods of time, but would like to leave the engine running and the climate controls on. To perform Valet Take-Over: 1. Before turning off the engine, press and release * 2. control for 1 second. Turn the ignition key to the OFF position.
Battery Information The remote control is powered by two 3V, CR20 16 batteries. When the battery begins to weaken, operating range is reduced and the LED on the remote control dims. BoHery replacement Locate the small slot on the side of the remote control. Insert a small slotted screwdriver or equivalent tool into slot and pry the case apart. Replace battery, while verifying the correct polarity and then snap case back together. BoHery Disposal Directed cares about the environment.
Government Regulations This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: ( 1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesirable operation. This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules.
---------·-- ----·----··-·--·----------------··-----·----- -·- -- - The following safety warnings must be observed at all times: Due to the complexity of this system, installation of this product must only be performed by an authorized Directed dealer. When properly installed, this system can start the vehicle via a command signal from the remote control. Therefore, never operate the system in an enclosed area or partially enclosed area without ventilation (such as a garage).
the Neutral Safety Shutdown Circuit test, the remote start unit has not been properly installed. The remote start module must be removed or the installer must properly reinstall the remote start system so that the vehicle does not start in gear. All installations must be performed by an authorized Directed dealer. OPERATION OF THE REMOTE START MODULE IF THE VEHICLE STARTS IN GEAR IS CONTRARY TO ITS INTENDED MODE OF OPERATION.
Limited lifetime consumer_wononty____. Directed Electronics.
IN THE EVENT OF A CLAIM OR A DISPUTE INVOLVING DIRECTED OR ITS SUBSIDIARY, THE VENUE SHALL BE SAN DIEGO COUNTY IN THE STATE OF CALIFORNIA. CALIFORNIA STATE LAWS AND APPLICABLE FEDERAL LAWS SHALL APPLY AND GOVERN THE DISPUTE. THE MAXIMUM RECOVERY UNDER ANY CLAIM AGAINST DIRECTED SHALL BE STRICTLY LIMITED TO THE AUTHORIZED DIRECTED DEALER'S PURCHASE PRICE OF THE UNIT.
DIRECTEDe The company behind Viper® Auto Security Systems is Directed. Since its inception, Directed has had one purpose, to provide consumers with the finest vehicle security and accessories available. The recipient of nearly 100 patents and Innovations Awards in the field of advanced electronic technology. Quality Directed products are sold and serviced throughout North America and around the world. Call ( 800) 876-0800 for more information about our products and services. © 2012 Directed.
Remote start, 6-pin connector Quick Reference Install Guide Remote Start with Keyless Entry Model 4105 Wiring Connections Main Harness, 9-pin connector 1 RED (+) (30A) HIGH CURRENT 12V INPUT 2 PINK/WHITE OUTPUT TO SECOND IGNITION/ACCESSORY CIRCUIT 3 RED (+) (30A) HIGH CURRENT 12V INPUT 4 ORANGE OUTPUT TO ACCESSORY CIRCUIT 5 PURPLE OUTPUT TO STARTER CIRCUIT 6 PINK OUTPUT TO PRIMARY IGNITION CIRCUIT Satellite harness, 4-pin connector 1 LIGHT GREEN BLACK (-) 200mA FACTORY ALARM DISARM
Programming System Features Feature Menus Remote Programming The System Features Learn Routine dictates how the unit operates. It is possible to access and change most of the feature settings using the Valet button. Default settings are in bold type. 1. 2. 3. 1. 2. 3. 4. 5. Turn the ignition on, then off. Select a Menu. Press and hold the Valet button. The number of LED flashes and horn honks indicates the menu number. A single LED flash and honk indicates menu 1.
Remote stort, 6-pin connector Quick Reference Install Guide OUTPUTTO PRIMARY IGNITION CIRCU IT Remote Start with Keyless Entry Model4105 OUTPUT TO STARTER CIRCUIT OUTPUT TO ACCESSORY CIRCUIT (+) (30A) HIGH CURRENT 12V INPUT OUTPUT TO SECON D IGNITION/ACCESSORY CIRCUIT Wiring Connections (+) (30A) HIGH CURRENT 12V INPUT Installation Points Reset nod Deletion_ · - -- -- - - - - - - - ~mill~-------------------- If a fea ture/virtual tach needs to use the following procedure.
11:ogromming.5ys.tem£eatures_______________ Default settings are in bold type. The System Features learn Routine dictates how the unit opera tes. It is fXJssible to access and change most of the fea ture settings using the Valet button . 1 2. 3. 4. 5. Remo.teJlr.ogromUJJmtJUingH--~~- Eeature_Menus_ 1 Turn the ignition on, then off. Select a Menu. Press and hold the Valet button.
A VEHICLE EQUIPPED WITH A DEl ® REMOTE START SYSTEM A If vehicle battery is disconnected, the system may attempt to start when the battery is reconnected or transmitter is used. Press brake to disengage. Check with vehicle owner to determine if hood pin switch or override switch was installed to disengage the system for service. A.;~ ~.......... -. IMPORTANT SAFETY NOTICE r. ,.
Please send products and other correspondence to: Directed 1 Viper Way Vista, CA 92081 X F R.O 1-01 DIRECTED® PO BOX 174391 DENVER CO 80217-4391 11 •• 1.11 ••••• 1.1 ••• 111 ••• 1.1 •• 1•• 11.1.1 ••••• 111.1 ••••• 11.1.1.1 DIRECTED® PRODUCT REGISTRATION Protect Jbur lnreslnJIIJt Register your product now to receive these benefits: -- ~ Owner Verification Proof of purchase in case of product theft or loss ~ Efficient Warranty Service In case there is a problem with .
IMPORTANT! D I RE CTE D · . . ® IMPORTANT! Please complete and return within the next 10 days or register online at productregister.com/directed. XFR01 1. 1. D Mr. 3. D Ms. 2. D Mrs. 4. D Miss Initial 2. Your date of birth: Month 3. Marital status: Last Name 11. How did you first become aware of this product? (check one) 01. D Local newspaper 07. D Radio commercial 02. D Yellow pages 08. D Salesperson's 03. D Magazine Ad recommendation 04. D TV commercial 09. D Motorsports 05. D Magazine.
