Viper 320HV Owner's Guide
Limited Lifetime Consumer Warranty For a period of five calendar year from the date of purchase of this auto-security device, Directed Electronics, Inc.
TO THE MAXIMUM EXTENT ALLOWED BY LAW, ANY AND ALL WARRANTIES ARE EXCLUDED BY THE MANUFACTURER AND EACH ENTITY PARTICIPATING IN THE STREAM OF COMMERCE THEREWITH. THIS EXCLUSION INCLUDES BUT IS NOT LIMITED TO THE EXCLUSION OF ANY AND ALL WARRANTY OF MERCHANTABILITY AND/OR ANY AND ALL WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE AND/OR ANY AND ALL WARRANTY OF NON-INFRINGEMENT OF PATENTS, IN THE UNITED STATES OF AMERICA AND/OR ABROAD.
Table of contents Limited Lifetime Consumer Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . i What is included . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Important information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 System maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Your warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2 © 2004 Directed Electronics, Inc.
What is included ➤ A control module ➤ Two 3-button remote transmitters ➤ A impact sensor on-board the control module ➤ A high-powered siren ➤ A fault-proof starter interrupt relay on-board the control module ➤ An LED system status indicator ➤ A push-button Valet® switch Important information Congratulations on the purchase of your state-of-the-art vehicle security system. This system has been designed to provide years of trouble-free operation.
➜ Your warranty Your warranty card must be returned and the barcode serial number must not be removed. If the warranty card is not returned, no warranty will be honored on your unit. It is also necessary to keep your proof of purchase, which reflects that the product was installed by an authorized dealer. Make sure you receive the warranty card from your dealer. ➜ FCC id/notice This device complies with Part 15 of FCC rules.
Transmitter functions This system is programmable, making it possible to assign any remote button to any specific receiver function. The remote initially comes programmed with Standard Configuration, but may also be customized by an authorized dealer. ➜ Standard configuration Button Pressing arms the security system and locks the vehicle doors (if connected). Press and hold for Panic alarm. Button Pressing disarms the security system and unlocks the vehicle doors (if connected).
Button Pressing and holding Mode. + for 1.5 seconds activates the Panic Buttons An optional auxiliary convenience or expansion function that you have added to your system can be activated by pressing these buttons simultaneously. The auxiliary output controls _______________________. + Buttons An optional auxiliary convenience or expansion function that you have added to your system can be activated by pressing these buttons simultaneously. The auxiliary output controls _______________________.
➜ Arming You can arm the security system by pressing for one second. When the system arms, the siren will chirp and the parking lights will flash once. If the power door locks are controlled by the system, the doors will also lock. Once armed, the status LED will flash once per second to indicate that the system is actively protecting your vehicle. If you hear a second chirp after arming and notice that the status LED is flashing in a grouped pattern, this signals Bypass Notification.
keys from being locked in the vehicle. NOTE: If any protected entry point, such as a door or switch-protected trunk or hood, is open, Passive Arming will not engage. If a protected entry is opened during passive arming, the countdown starts over. Arming the security system protects your vehicle in the following ways: 8 ➤ Light impacts trigger a warn away response, causing the siren to chirp and the parking lights to flash for a few seconds.
➜ Disarming Press to disarm the security system. If the power locks are controlled by the system, the doors will also unlock. Disarming is confirmed when the parking lights flash twice and the siren chirps twice. If the siren chirps more than two times and the LED continues to flash after pressing the button, the system was triggered in your absence. Refer to the disarming diagnostics section to determine the cause.
➜ Panic™ mode If you are threatened in or near your vehicle, you can press for 1.5 seconds to trigger Panic Mode on your security system and attract attention. The siren will sound and the parking lights will flash for 30 seconds. To stop Panic Mode at any time, press . Also, pressing and holding the button will activate the Panic Mode. ➜ Silent™ mode Use the remote-controlled silent arm/disarm to temporarily turn off the arm or disarm chirps by briefly pressing pressing before .
You can access Valet® Mode either manually or from the remote. To enter or exit Valet® Mode with the Valet® button: 1. Turn the ignition on. 2. Turn the ignition off. 3. Press and release the Valet® button within 10 seconds. DRW-35 The status LED will light solidly if you are entering Valet® Mode and will turn off if you are exiting Valet® Mode. ➜ Valet™ mode using a transmitter You can also enter or exit Valet® Mode by using the remote transmitter: 1. Open any vehicle door. 2. Press 3. Press 4. Press .
➜ Nuisance Prevention Circuitry (NPC)™ Your security system has Nuisance Prevention Circuitry™ (NPC™) to prevent annoying false alarms. This circuitry is designed to prevent repetitive trigger sequences due to faulty door pinswitches or environmental conditions such as thunder, jackhammers, airport noise, etc. Here's how it works: If the alarm is triggered by the same sensor or switch three times within a 60 minute period, your system interprets this pattern of triggers as false alarms.
Diagnostics The microprocessor at the heart of your system has the ability to constantly monitor all of the switches and sensors connected to it. It can detect any faulty switches or sensors and prevent them from disabling the entire system. It can also record and report any triggers that occur when you are away from your vehicle. ➜ Arming diagnostics If the system is armed at the same time that an input is active (door opening, sensor triggering, etc.
➜ Disarming diagnostics Your system has a Tamper Alert feature that notifies you of system triggers that occur while you are away from your vehicle. If you hear four chirps when you disarm, this indicates that the system was triggered in your absence. If you hear five chirps when you disarm, this indicates that a specific zone was triggered so many times that the NPC™ has bypassed that zone. In both cases, the pattern of the flashing status LED indicates which zone was triggered (see Table of Zones).
➜ Table of zones A zone is represented by the number of LED flashes used by the system to identify a particular type of input. Standard input assignments are listed in the following table, along with spaces to write in any optional sensors or switches that you have had installed.
ily out of sync and fail to operate the system. To resynchronize the transmitter, simply press several times within range of the vehicle. The system will automatically resynchronize and the transmitter will respond normally. High frequency Your system transmits and receives at 434 MHz. This provides a cleaner spectrum with less interference and a more stable signal. Enjoy a phenomenal increase in range, even in areas with high radio interference.
➤ Ignition controlled door lock feature, on or off. With this feature on, the doors will lock three seconds after the ignition key is turned on, and unlock when the ignition is turned off. The system also prevents the doors from locking when the ignition is turned on while any vehicle door is open. Security & convenience expansions Listed below are some of the many expansion options available for use with your system. Please consult your dealer for a detailed explanation of all the available options.
If programmed On the door lock output will activate the Comfort Close output for 20 seconds. This output will begin 0.2 seconds after the final door lock output has completed regardless of the door lock programming. If while the 20 second timer is active and closing the windows the user disarms the unit, the Comfort Close output will immediately cease before the doors unlock.
Power Window Control: Automatic power window control is provided with the 529T systems. These options operate power windows, by rolling them up, down, or both up and down. The 530T also offers one-touch switch operation.
Interior Light Illumination: The interior domelight can be configured to illuminate for 30 seconds after the alarm is disarmed. If the system is rearmed during that 30-second period, the interior light illumination will terminate until the alarm is disarmed once again. 20 © 2004 Directed Electronics, Inc.
Glossary of terms Control Module: The "brain" of your security system. Usually hidden underneath the dash area of the vehicle. It houses the microprocessor that monitors your vehicle and controls all of the security system’s functions. Fault-Proof Starter Interrupt: Located on-board the control module, this is an automatic switch controlled by the security system that prevents the vehicle's starter from cranking whenever the security system is armed.
Transmitter: A hand-held, remote control that operates the various functions of the security system. Trigger or Triggered Sequence: The "setting off" or "tripping" of the alarm. A triggered sequence consists of the siren sounding and the parking lights flashing for 30 seconds. Valet Switch: A small, push-button switch mounted inside the vehicle, at a location determined by the installer.
✂ QUICK REFERENCE GUIDE ■ Press of your transmitter for one second. When the system arms, you will hear a short siren sound, or chirp, and see the parking lights flash once. If the vehicle's power door locks are controlled by the system, the doors will lock. Disarming: ■ Press again. You will hear two chirps, and the parking lights will flash twice. If the power door locks are controlled by the system, the doors will unlock. Disarming without a transmitter: ■ Turn on the ignition.
The company behind this system is Directed Electronics, Inc. Since its inception, Directed Electronics, Inc. has had one purpose, to provide consumers with the finest vehicle security and car stereo products and accessories available. The recipient of nearly 100 patents and Innovations Awards in the field of advanced electronic technology, Directed Electronics, Inc. is ISO 9001 registered. Quality Directed Electronics products are sold and serviced throughout North America and around the world.
