Installation guide

feature descriptions

1 ACTIVE/PASSIVE ARMING: When active arming is selected, the system will only arm when the transmitter is

used. When set to passive, the system will arm automatically 30 seconds after the last door is closed. Passive

arming is indicated by the rapid flashing of the LED when the last protected entry point is closed.

2 CONFIRMATION CHIRPS ON/OFF: This feature controls the chirps that confirm the arming and disarming of

the system.

3 IGNITION-CONTROLLED DOOR LOCK/UNLOCK ON/OFF: When turned on, the doors will lock three seconds

after the ignition is turned on and unlock when the ignition is turned off. If the ignition key is turned on while

the vehicle door(s) are open, the door(s) will not lock.

4 ACTIVE/PASSIVE LOCKING: If passive arming is selected in Feature 1, then the system can be programmed

to either lock the doors when passive arming occurs, or only lock the doors when the system is armed with the

transmitter. Active locking means the system will not lock the doors when it passively arms. Passive locking

means that the system will lock the doors when it passively arms.

5 DOOR LOCK PULSE DURATION: Some European vehicles, such as Mercedes-Benz and Audi, require longer lock

and unlock pulses to operate the vacuum pump. Programming the system to provide 3.5 second pulses will

accommodate door lock interface in these vehicles. The default setting is 0.8 second door lock pulses. See

Mercedes-Benz and Audi - 1985 and Newer (Type E Door Locks section) diagram.

6 DOUBLE PULSE UNLOCK OFF/ON: Some vehicles require two pulses on a single wire to unlock the doors. When

the double pulse unlock feature is turned on, the H2/3 BLUE wire will supply two negative pulses instead of a

single pulse. This makes it possible to directly interface with double pulse vehicles without any extra parts.

7 COODE HOPPING TECHNOLOGY ON/OFF: This system features Code Hopping Technology as an option. Code

Hopping Technology is a feature that uses a mathematical formula to change the system’s code each time the

transmitter and receiver communicate. This makes the group of bits or "word" from the transmitter very long.

The longer the word is, the easier it is to block its transmission to the unit. Disabling the Code Hopping

Technology feature lets the receiver ignore the Code Hopping Technology part of the transmitted word. As a

result, the unit may have better range with Code Hopping Technology off.