Installation guide

transmitter/receiver remote control code learning

The system comes with two transmitters that have been taught to the receiver. Use the following

transmitter/receiver remote control code learning to add transmitters to the system or to change button assign-

ments if desired.

The Valet®/Program button, plugged into the blue port, is used for programming. There is a basic sequence to

remember whenever programming this unit: Door, Key, Choose, Transmit and Release.

1. Open a door. (The GREEN wire, H1/5, or the VIOLET, H1/7 must be connected.)

2. Key. Turn the ignition on. (The H1/9 YELLOW switched ignition input must be connected.)

3. Select the receiver channel. Press and release the Valet®/Program switch the number of

times necessary to access the desired channel. Once you have selected a channel, press

and HOLD the Valet®/Program switch once more. The siren will chirp and the LED will blink

the number of times corresponding to the channel that has been accessed.

NOTE: If adding a remote, a button must be taught to Channel 1 prior to programming other channels.

CHANNEL PRESS AND RELEASE

NUMBER THE VALET/PROGRAM SWITCH TO PROGRAM FUNCTION

1 One Time Arm/Disarm/Panic

2 Two Times Channel 2

3 Three Times Channel 3

4 Four Times Arm Only

5 Five Times Disarm Only

6 Six Times Panic Only

7 Seven Times Auto-learn* for 3-button transmitters

8 Eight Times Delete all transmitters**

*NOTE: The Auto-learn function cannot be used to program an optional four-button transmit-

ter; the channels must be taught to the transmitter individually. See Transmitter Configuration

section of this guide for a description of Auto-learn transmitter programming.

**NOTE: If any button from a known transmitter is programmed to Channel 8, all transmitters

will be erased from memory and will revert to the default feature settings. (See Features Menu

section of this guide.) This is useful in cases where one of the customer's transmitters is lost or

stolen. Channel 8 will erase any lost or stolen transmitters from the system's memory and can

also be used to start from scratch if the transmitter buttons were programmed incorrectly.