Installation guide

© 2008 Directed Electronics Vista, CA 17
starter interrupt harness (H3) wire connection guide
______
______
Use one of these wire as a starter interrupt input and the other as a starter interrupt output wire
NOTE: These two black wires are interchangeable.
plug-in LED and valet/program switch
The LED and the Valet/Program switch both plug into the control module. The LED system status indicator plugs
into the white two-pin port, while the Valet
®
/Program switch should be plugged into the blue two-pin port. The
status LED and Valet
®
/Program switch each fit into
9
/32-inch holes.
LED System Status Indicator Valet
®
/Program Switch
DIA-41
H3/1 and H3/2 BLACK starter interrupt wires
BLACK STARTER INTERRUPT OUTPUT
BLACK STARTER INTERRUPT INPUT
H3/1
H3/2