Installation guide

UltiMate
®
3000 Viper™ Capillary Kits for Intelligent LC (LCi) System Solutions
Quick Installation Guides
January 2010 Rev. 02 Page 35
© 2010 Dionex
6.4.2 Dual-stack with Extension Kit
The figure below shows the schematic setup of the Method Scouting configuration with the
extension kit as a dual-stack, supporting up to 13 different eluents. Install your Viper
capillaries according to the information of Table 15 and the system stack schematic ( 6.3.2).
Note: All columns have to be operated at the same column temperature; in
order to allow for fast and easy system flushing, one column can be
replaced with a suitable capillary as a bypass (not included in delivery),
or a column can be replaced by a Viper union to directly connect the
two valves. The delivery contains colored capillary clips for color-
coding of the capillaries. For detailed information on the installation of
the solvent selection valve, please refer to the related documentation.
Figure 17: Flow schematic of the Method Scouting setup with extension kit (dual-stack)