Installation guide

UltiMate
®
3000 Viper™ Capillary Kits for Intelligent LC (LCi) System Solutions
Quick Installation Guides
Page 14 Rev. 02 January 2010
© 2010 Dionex
2.3 Stacking the Modules
Please stack the modules as shown below. The picture is a schematic to illustrate the course of
the flexible Viper capillaries in general. Dionex recommends installing all capillaries inside
the modules as needed.
SRD-3600 Solvent Rack and Degasser
DGP-3600RS/SD Dual-Gradient Pump
WPS-3000(T)SL/(T)RS
inline Split Loop Autosampler
TCC-3000RS/SD Thermostatted Column
Compartment with 1x 2-position 10-port
switching valve (right)
Stackable Dionex Detector
Important: All modules are primed with 2-propanol at the factory. Prior to initial
operation of the system, make sure that all used solvents are miscible
with 2-propanol and equilibrate your system. Otherwise, perform
appropriate intermediate flushing steps.