Specifications

Viper Installation and Operators Manual 2.08

The following table discusses the alarms and the conditions that will set off the alarm.

Alarm Condition

Off Rate

This alarm activates when the actual application rate differs from

the specified percentage rate for more than five seconds, This

alarm activates only when the system is in Auto mode. The

alarm automatically clears when the target rate and actual rate

are within the specified range or when the product mode is

switched to either Manual or Off.

Low Limit

This alarm activates when the volume per minute has dropped

below the specified limit. This alarm activates only when the

system is in Auto Mode. The alarm automatically clears when

the volume per minute rises above the specified limit or when the

product mode is switched to either Manual or Off.

Low Tank

This alarm activates when the tank volume has dropped below the

specified limit. The alarm can be cleared when you either enter a

value that is above the low tank value or when you enter a zero in

the Low Tank field.

Flow/Shaft

For an injection application, the Flow alarm is active. This alarm

activates to indicate a loss of product flow. For a granular

application, the Shaft alarm is active. This alarm activates when

the shaft sensor in a granular application does not detect shaft

rotation. You must troubleshoot the system to determine the

cause of the alarm and clear it.

Vac/Bin

For an injection application, the Vac alarm is active. This alarm

activates when the vacuum sensor detects a vacuum in the tank.

You must troubleshoot the system to determine the cause of the

alarm and clear it. For a granular application, the Bin alarm is

active. This alarm activates when the bin level sensor detects

that the granular level in the bin drops below the sensor.

Dual Flow

This alarm activates for an injection application system when the

flow switch monitor and the actual flow readings are out of the

specified tolerance. This alarm also activates when Gran 3 is

selected as the application type and the rates sensed by the dual

encoders are out of the specified tolerance.

Zero Speed

This alarm activates when the speed of the vehicle drops below

0.7 MPH and the Zero Shutoff function is enabled. Cycle the

master boom switch to clear the alarm and resume product

control.