Specifications

Manual # 016-0159-894 Rev H 01/07
51
2-Setting Up the Controller Area
5. Press the Next button. The Max PWM Calibration screen will display.
6. Adjust the PWM setting for the maximum desired setting.
a. Press the up arrow button until the maximum desired pressure is
observed on the pressure indicator in a liquid application or the belt
runs at the maximum desired speed in a granular application.
b. Press the down arrow button until the pressure drops to just below
the maximum desired pressure in a liquid application or the belt begins
to slow down in a granular application
Helpful Hint: You can increase or decrease the step sizes for the up
arrow and down arrow buttons by either selecting 1 or 10 for the step
size.