Specifications

Manual # 016-0159-894 Rev H 01/07

2-Setting Up the

Controller Area

Min PW

You can use this feature to set the minimum desired RPM or hydraulic output (zero point

or shutoff point) for a Pulse Width (PW) Modulated control valve. To set the minimum

pulse width:

1. Press the data 2 window on the CAN Controller Status screen. The first Node

1 Settings screen will appear. Press NEXT. If PWM has been set as the valve

type, a PWM Calibration Assistance button will appear.

2. Press the PWM Calibration Assitance button. The Min PWM Calibration

screen will appear. (Liquid mode shown)