Specifications

Manual # 016-0159-894 Rev H 01/07

2-Setting Up the

Controller Area

Tank Volume

You can enter the estimated volume of the tank that you are using in this field. Each

time you refill the tank you must re-enter this value if you are using the Low Tank

Alarm feature.

Area/Hour

Displays the area per hour of product application. This is a display only.

Vol/Min

Displays the volume per minute of product application. This is a display only.

Rate Cal

You can enter the target rate for the product you are applying.

Rate +/-

You can select the increment at which the Rate Cal is increased or decreased while

using the ‘Auto’ feature. This is also referred to as the rate ‘bump’.

Meter Cal/Density

You can enter the meter calibration when you are applying a liquid application. This

number is typically found on the flow meter.

Enter the product density (weight of 1 cubic foot of product) here if you are applying a

granular application.

Spreader

You can enter the spreader constant when applying a granular product.

Important: Enter a zero in this field when applying liquid

products.