Specifications

Manual # 016-0159-894 Rev H 01/07
29
2-Setting Up the Controller Area
2. Press Ye s. The Re-Address CAN Nodes screen displays.
3. Cycle the power to the product 1 node. To cycle the power, disconnect the
logic power from the node and then reconnect the logic power to the node.
4. Press Next to cycle the next product node in the system.
5. Repeat steps 3 and 4 until you have re-addressed all nodes on the system.
6. Press Finish.
7. Press Start Viper when all the product nodes in the system display as ‘Found’.
Programming
the Nodes on
the CAN
System
Once you have established proper communication between the product nodes on the
CAN bus and the Viper console, you must now program the product nodes. You can
program the nodes by pressing the Product Control area in the main screen.
The following seven areas display information on the screen:
 Boom Cals
 Miscellaneous
 Data Box 1
 Data Box 2
 Pressure Area
 Application Area
 Tally Registers
 Alarms