Specifications

Manual # 016-0159-894 Rev H 01/07
315
3. Press Tally Registers.
4. Press the Reset button next to the Distance box.
5. With a small jumper wire (or paper clip), short between the 10 o’clock and
6 o’clock sockets with a ‘short-no-short’ motion. Each time contact is made,
the Distance total should increase by increments of 1 or more.
6. If the Distance total does not increase, remove the section of cable and
repeat the test at the connector that is the next closest to the node. If the
distance total now increments as you do the short-no-short test, replace the
defective cable as required.
7. If no pulses are registered, perform the above voltage checks.
8. If all of the cables test ‘good’, replace the Speed Sensor.
Remember: After testing is complete, re-enter the correct
Speed Cal and Speed Sensor type before starting application.