Specifications

Manual # 016-0159-894 Rev H 01/07
293
12 - Troubleshooting
General Error Messages
Setup Error Messages
Issue Possible Cause Solution
Booms must be
Booms are not Configure the boom in a left-to-right order. See
specified in left-to-
configured Chapter 3, Boom Settings and Mapping for more
right order
sequentially in a information on configuring booms.
left-to-right
order
There is a gap or
Improper values Check the boom setup values entered for Left/
overlap between
entered into Right, and check the booms you have entered for
boom sections
either boom this product. Set up boom sequentially from left-
widths and/or to-right. Left/Right value is measured from center
the left/right of boom.
values for
individual boom
sections.
Boom select Boom select must specify individual booms for
functions not individual products if a gap or overlap is detected.
properly
configured.
Error
Messages
The following table provides issues and solutions about error messages displayed on
the Viper system.
Issue Possible Cause Solution
Storage card not
Flashdisk is Turn off the power to the Viper console, insert the
found. Viper
missing flashdisk, and turn the Viper console on again.
program connot
continue…
The Activation
Incorrect Re-enter the Activation key. If this still does
key you have
Activation not work, contact your Raven representative.
entered is not
key entered
valid
Scout file error
Scout file for Press
OK
to bypass.
one of the jobs is
missing
File is an older Press
OK
to bypass.
version and not
compatible with
the current
software release
JobMap error
Scout file for job Press
OK
to bypass and create a scout file for the
is missing current job.