Specifications

242
Viper Installation and Operation Manual 2.08
All consecutive swath paths are based on the original A-B swath path points.
Helpful Hint: Viper displays a distance to headland
countdown when you are approaching or leaving the
headlands area.
Spiral
The Spiral pattern allows you to set a swathing pattern that is based on an
outside boundary and works toward the center of the field.
Setting the Spiral Pattern
During the job setup, select Spiral as the swath pattern.
Once the job is started:
1. Enter the boundary area of the field and press Begin Boundary.
2. Drive the boundary of the field. Viper records the path you drive
around the boundary.
3. Press End Boundary when you have completed the first boundary
pass.
Remember: Viper will automatically close the boundary
when the vehicle is within one boom length from the Begin
Boundary set point.
4. Drive the next swath path through the field. Viper uses the original
boundary pass as guidance through the field and is one swath path
width to the inside from the original boundary swath path.