Specifications

238
Viper Installation and Operation Manual 2.08
Headlands Separate
The Headlands Separate pattern allows you to set a straight swathing pat-
tern for a field that has a headland area around the boundary of the field.
Setting the Headlands Separate Pattern
During the job setup, select Headlands Separate as the swath pattern.
Once the job is started:
1. Enter the headland area and press Begin Boundary.
2. Drive the boundary of the field. Viper records the path you drive
through the headlands area.
3. Press End Boundary when you reach the end of the boundary.
Remember: Viper will automatically close the boundary
when the vehicle is within one boom length from the Begin
Boundary set point.
4. Turn into the field and press Set A to start the first swath path.
5. Drive to the end of the boundary and press Set B. The first swath
path is now set.
Viper assigns the second swath path based on the direction in which you turn
the vehicle after you have pressed Set B. All consecutive swath paths are
based on the original A-B swath path points.
Helpful Hint: Viper displays a distance to headland
countdown when you are approaching or leaving the
headlands area.