Specifications

237
Manual # 016-0159-894 Rev H 01/07
8 - Viper Guidance
C Clamp
The C Clamp pattern allows you to set a straight pattern for a field with
double headlands on two opposite sides of the field.
Setting the C Clamp Pattern
During the job setup, select C Camp as the swath pattern.
Once the job is started:
1. Enter the field in the direction of the double headland and press
Set CClamp 1.
2. Drive to the end of the first headland pass and press Set CClamp 2.
3. Turn back into the first headland pass and drive to the end of the
headland. Viper guides the vehicle based on the first pass through
the headland.
4. Press End Pass 2 at the end of the first headland.
5. Turn in the direction in which you want A-B guidance for the field.
6. Press Set A to start the first swath path.
7. Drive to the end of the first swath path and press Set B. Viper
uses this set of A-B points to guide the vehicle through the field.
8. Turn towards the second headland pass and press Set CClamp 3.
9. Drive to the end of the second headland pass and press Set
CClamp 4.
10. Turn back into the second headland pass and drive to the end of the
headland. Viper guides the vehicle based on the first pass through
the second headland.
11. Press End Pass 2 at the end of the second headland.
12. Turn in the direction in which you want to start the second swath.
Viper uses the original A-B points to guide the vehicle through the
field.
Helpful Hint: Viper displays a distance to headland
countdown when you are approaching or leaving the head-
lands area.