Specifications

236
Viper Installation and Operation Manual 2.08
Contour 2 Button
The Contour 2 Button pattern allows you to set a curved swath pattern
based on the last swath path driven.
Setting the Contour 2 Button Pattern
During the job setup, select Contour 2 Button as the swath pattern.
Once the job is started:
1. Press Set A to start the first contoured swath path.
2. Drive to the end of the first contoured swath.
3. Press Set B. The first swath pattern is now set. Viper uses this
swath pattern for the second swath through the field.
4. Press Set 2A at the start of the second swath path.
5. Drive to the end of the second swath path and press Set 2B.
Viper uses this swath pattern for the third swath through the field.
6. Repeat steps 4 and 5 for each consectutive swath through the
field.