Specifications

233
Manual # 016-0159-894 Rev H 01/07
8 - Viper Guidance
Straight AB
The Straight AB pattern allows you to set a straight swathing pattern that
is based on the first pass driven.
Helpful Hint: The Guidance screen will display once
you are in the job.
Setting the Straight AB Pattern
During the job setup, select Straight AB for the swath pattern.
Once the job is started:
1. Press Set A to start the first swath path.
2. Drive to the end of the first swath path.
3. Press Set B. The first swath path is now set.
Viper assigns the second swath path based on the direction in which you
turn the vehicle after you have pressed Set B. All consecutive swath
paths are based on the original A-B swath path points.