Specifications

220
Viper Installation and Operation Manual 2.08
The current status of Autoboom can be quickly and easily determined by
viewing the Autoboom area on the Viper main screen. The following
status indicators will display in the AutoBoom area on the Viper main
screen.
Autoboom
Status
Display
Autoboom is detected and calibrated but
currently turned off. Turn on Autoboom to
use.
Autoboom is detected but is not
calibrated. You must calibrate Autoboom
before you can use it.
Autoboom was detected but
communication has been lost.
Troubleshoot Autoboom.
Autoboom is detected and on but is not
enabled. Press on the two A's to enable
Autoboom.
Autoboom is detected and in operation.
No errors are detected in the operation.
Autoboom is detected but is not enabled.
Alarm conditions have occurred on both
booms. Troubleshoot.
Autoboom is detected and is enabled.
Alarm conditions have occurred on both
booms. Troubleshoot.
The operation of the booms under Autoboom control should be very smooth
and not erratic. If the up and down motion of the booms does not seem as
smooth as it should be, you can adjust the up and down movement of the
booms.
Adjusting
Autoboom
Operation