Specifications

212
Viper Installation and Operation Manual 2.08
Helpful Hint: If no sensors are detected when
PowerGlide Plus mode is selected, UltraGlide will
operate in the PowerGlide Plus mode. Use the
calibration instructions under Calibrating PowerGlide
Plus in the following section to calibrate UltraGlide
in PowerGlide Plus mode.
3. Press the CAL Left button to start the automatic calibration
of the left boom.
Important: The left boom will lift into the air and then
fall. This is part of the calibration process. Use
caution to be sure the area is clear of people or hard-
ware before starting the process.
4. The CAL Left button will change to a STOP CAL button and
‘Calibrating’ will flash under the button. This indicates that
the calibration process has begun.
Helpful Hint: The calibration process may take one
to two minutes to complete. The flashing
‘Calibrating’ display will indicate that calibration is in
process.