Specifications

Manual # 016-0159-894 Rev H 01/07
199
6 - Using AccuBoom
5. Select an offset shift for the boundary that is in relationship to one-half the
boom width.
6. Press OK. Viper draws the boundary line on the Scout map as you drive
around the boundary.
7. To close the boundary, press Finish.
Helpful Hint: Spray/No-Spray zones do not have the
auto close feature. You will need to select Finish and the
Zone to finish at the end of the boundary.
8. Repeat steps 3 to 7 for each Spray or No-Spray boundary you want to
define.
Once a zone is created, it can be viewed on the Scout tab and on the AccuBoom tab.
The AccuBoom tab will show all finished zones as well as allow you to create the
finished AccuBoom Spray/No-Spray map when all zones have been defined.
Important: Any area not defined will default to a spray zone.
However, if the create boundary selection has been checked, it
is important to create the outer boundary of the field as a spray
zone.
Helpful Hint: If you have previously selected to use an existing
field boundary, the selected field boundary will be automatically
created as a spray zone. The create boundary selection will
automatically be displayed and you will be able to create additional
zones if desired.
Once you have created all the spray and no spray zones desired for the job, you are
ready to start the AccuBoom Spray/No-Spray map:
9. On the main screen, select the AccuBoom tab.