Specifications

Viper Installation and Operators Manual 2.08
188
AccuBoom Control Setup
Before you can access and setup AccuBoom, you must have previously purchased
the proper supporting hardware components.
The AccuBoom Control Setup screen allows you to configure the AccuBoom func-
tion. To access this screen, touch the Booms area on the main screen.
Important: In a CAN AccuBoom installation, if you have a Boom/
Speed node installed that is prior to PGM D, the AccuBoom tab will
be grayed out and you will receive a warning message.
Look-Ahead
You can use the AccuBoom feature in combination with the Look-Ahead feature to
enter an AccuBoom “look-ahead” value. AccuBoom Look-Ahead helps compen-
sate for the lag due to the time for valves to open and close and the time for lines to
gain pressure or be relieved of pressure.
Turn-Off % Coverage
This value controls the percentage of the boom that must be inside a previously
applied area in order for the boom to turn off. The default value is 80%. This would
require that 80% of the boom be in the previously applied area before it would turn
off.
Note: If the value is set to 0%, the boom will not turn off
automatically.