Specifications

Viper Installation and Operators Manual 2.08
152
You can select different options to run for the job, based on the features you previ-
ously purchased. The following features are available:
 Product Application
 Swath Guidance
 AccuBoom Control
Product Application
The Product Application feature allows you to:
 Communicate with a Raven product control system
 Log an application
 Variable rate with reference to a prescription map
If you have a multi-product vehicle and you want to use the variable rate function,
you must purchase the multi-product VRA feature.
Depending upon the type of Raven console you have your Viper console connected
to, you can apply a number of different products.
If you are connected to a Raven single product console or a single product Raven
CAN bus system, you can apply only one product. You do not have the ability to
apply mulitiple products.
If you are connected to a Raven multiple product console or a mulitiple product
CAN bus system, you can apply up to five products.
Viper handles the product selection in a sequential manner, so you must select the
location on the unit from where the product is applied. If you are using a mulitiple
product controller or CAN bus system and you want to apply only products 4 and 5,
you must select 5 for you product selection. If you want to apply products 1 and 2,
you should still select 5 for your product selection.
The product selection screen references the number of product control channels on
the vehicle, not the actual number of products you are applying. For example, if you
are applying only product 1, but the tank contains a mixture of three different chemi-
cals, you must enter a 1 in the product selection screen. This screen will only allow
you to enter the number of products available for application.
The Product Selection screen also allows the user to select the ‘Enable Product
Chaining’ option. With this option selected, the user will be able to select which
products to chain together and set the sequence in which the products will be used.
See the Product chaining section in Chapter 5 for more information on this feature.